Web i go over all the basics on wiring up your vehicle trailer harness and electric brakes. Get ready for trailer wiring installation. The next step is to run the wires from the brake controller to the trailer brakes.
Wiring Electric Brakes On A Trailer / Winning at Trailer Brake Wiring
Connect the brown wire to the tail lights on both sides of the trailer and to the side marker lights.
Gather The Necessary Tools And Parts.
Pull off the old wiring. Web electric brakes use a sensor controlled by the tow vehicle’s brake lights. You need to run four wires:
Web First, I Need To Remove The Metal Crimp, So I Cut It Out.
Pull out each nut on the junction box using a screwdriver. If the trailer is over 80 inches wide also connect the brown wire to the. The power is sent to the rear wheels.
Make Sure That You Have Everything Necessary To Wire Your Trailer.
The brake controller is activated when the lights are on. Blue = electric brakes or. Web generally, to wire trailer brake magnet:
Web The Brake Controller Is Responsible For Activating The Brakes At The Appropriate Time, While The Trailer Plug And Wiring Harness Are Used To Connect The.
Power, ground, brake switch, and brake. Use a crimper to cut about 2 to 5mm off your. To organize and secure your wiring, use a.
Next, I Snipped The Ends Of The Wires I Want To Reattach And Then Stripped The.
Raise the trailer and remove the wheel. It also talks about electric brake controller.thanks for watching !
